Cembre B1300-C Manual De Uso página 6

WARNING
Do not use the tool for purposes other than those intended by Cembre.
The operator should concentrate on the work being performed and be
careful to maintain a balanced working position.
Before starting work on electrical equipment, please ensure that either
there are no live parts in the immediate working area or that precautions
are taken for working near live par ts in accordance with EN50110-1.
Do not use this tool on or near energised conductors without proper
personal protective equipment. Failure to observe this warning could
result in severe injury or death.
The tool is unsuitable for continuous use and should be allowed to cool
down following uninterrupted, successive crimping operations; for instance,
having exhausted a fully charged battery in one session, delay battery
replacement for a few minutes.
Protect the tool from rain and moisture. Water will damage the tool and
battery. Electro-hydraulic tools should not be operated in pouring rain.
2. INSTRUCTIONS FOR USE
IMPORTANT: Never pressurise the tool without inserting the dies, this could
cause damage to the head and the ram.
The part reference includes the following (Ref. to Fig. 8 page 46):
A - Hydraulic crimping tool.
B - Li-Ion rechargeable battery (2 pcs).
C - Battery charger (model depends on the tool version).
D - Shoulder strap.
E - Plastic carrying case.
2.1) Preparation
The tool can be easily carried using either the main handle (11) or the shoulder strap attached to
the two rings (7) (Ref. to Fig. 5).
The main operating positions are : horizontal standing on its feet and vertical standing on its bat-
tery. In addition to the main handle (11) the lower handle (5) allows a safer and more balanced
grip when using two hands to hold the tool (Ref. to Fig. 3).
Before starting any work, check the battery charge (Ref. to § 2.8) and recharge
if necessary, following the instructions in the battery charger user manual.
6