Cembre B1300-C Manual De Uso página 7

To replace the battery, grip the tool as illustrated in Figure 1; press the release button (10) and
push the battery downward unlocking it.
Insert a charged battery from the bottom by sliding it into the guides until it locks.
The display shows the operational parameters of the tool; to customise them proceed
as described in § 2.7.
Select the appropriate die set for the connector.
When introducing or changing dies, the battery must fi rst be removed from the tool.
Insert one die into the upper seat of the tool head (Ref. to Fig. 2) until it is locked by retaining
pin (13). To ease the die insertion keep release pin (12) depressed.
Insert one die into the seat on the ram until it is locked by retaining pin (15).
To ease this operation, operate the tool (see § 2.2) to advance the ram (16) 8-10 mm (0.3 - 0.4 in.)
and keep release pin (14) depressed.
Insert the conductor into the connector (Ref. to Fig. 4).
Position the connector between the dies and ensure the correct location of the crimp (Ref. to
Fig. 4).
NOTE
: when more compression is
required, proceed according to the
sequence and direction indicated
in the fi gure, uniformly spacing the
compressions.
2.2) Die advancement
Press operating button (1) (Ref. to Fig. 4) to activate the
motor-pump and advance the lower die.
To halt the advancement, release operating button and
the motor will cut out.
Make sure the dies are exactly positioned on the desired crimp
point otherwise re-open dies following instructions as per
§ 2.4 and reposition the connector.
2.3) Compression
By keeping operating button (1) pressed, the motor continues to operate: the ram will gradually
move forward until the two dies touch.
The motor will stop automatically when the set pressure has been reached.
To perform proper compression, press and hold the operating button (1) until the motor
stops automatically.
7
terminal
2
1
2
connector
1
1
2
1