Publicidad
Idiomas disponibles
Idiomas disponibles
Burner Assembly/Maintenance
• Although your burners are constructed of stainless steel,
they may corrode as a result of the extreme heat and
acids from cooking foods. Regularly inspect the burners
for cracks, abnormal holes, and other signs of corrosion
damage. If found, replace the burner.
• DO NOT obstruct the flow of combustion and ventilation
air. Burner tubes can become blocked by spiders and
other insects building their nests. Blocked burner tubes
can prevent gas flow to the burners and could result in
a burner tube fire or fire beneath the grill. To clean the
Burner Assembly follow these instructions to clean and/
or replace parts of burner assembly or if you have trouble
igniting the grill.
1. Turn gas off at control knobs and LP cylinder tank valve.
2. Remove screw from each burner "foot" using a
screwdriver.
3. Carefully lift each burner up and away from valve
openings.
4. Use a narrow bottle brush or a stiff wire bent into a
small hook to run through each burner tube and flame
port several times.
Note: Wear eye protection when performing procedure 6.
5. Use compressed air to blow into burner tube and out the
flame ports. Check each port to make sure air comes out
each hole.
Valve Nozzle
Burner Opening
6. Wire brush entire outer surface of burner to remove food
residue and dirt.
7. Check burner for damage, if any large cracks or holes are
found replace burner. IMPORTANT: Burner opening must
slide over valve nozzle.
10
Debris
Crossover Channel
8. Orient burners CORRECTLY by aligning screw hole in
burner to the left as shown. Note: Make sure burner
tubes align evenly between cross over channels.
9. Replace screw on each burner. Relight burners to verify
PROPER BURNER OPERATION
proper operation.
Proper Care & Maintenance
• To protect your grill from excessive rust, the unit must be
kept clean and covered at all times when not in use.
• Wash cooking grills and heat distribution plates with hot,
soapy water, rinse well and dry. Lightly coat cooking grill
with vegetable oil or vegetable oil spray.
• Clean inside and outside of grill by wiping off with
a damp cloth. Apply a light coat of vegetable oil or
vegetable oil spray to the interior surface to prevent
rusting.
• The stainless steel exterior surface of your grill, can be
cleaned with stainless steel cleaner.
• Never apply paint to the interior surface. Rust spots
on the interior surface can be buffed, cleaned, then
lightly coated with vegetable oil or vegetable oil spray to
minimize rusting.
Cleaning and Maintenance
Correct care and maintenance will keep your appliance
operating smoothly. Clean regularly as determined by the
amount of use. NOTE: Clean the entire appliance each year
and tighten all hardware on a regular basis (1-2 times a
year or more depending on usage). Cleaning should be done
where detergents won't harm patio, lawn, or the like.
Suggested Cleaning Materials
• Mild dish washing liquid detergent
• Wire brush
• Nylon cleaning pad
• Hot water
• Paper clip
• Soft brass bristled brush
Burner Screw
Aligned Left
Publicidad
