SATA J Serie Manual Del Uso página 19

2. Speed regulation
Change the force applied to the switch to regulate the rotating speed. The range of adjustment is between 0 and the maximum rotating
speed. The smaller the force is, the lower the rotating speed is. The drilling starts slowly and stably. After the stable and reliable start,
press the switch fully for higher speed.
Speed position selection （see Figure C）
3.
First select the position, and then regulate the rotating speed by operating the switch; the highest position is selected at delivery and
there are three red position indicators （ 6） where three ones coming on means the high position, two ones coming on means the mid
position and one coming on means low position: Change the position once each time you press the mark.
Warning
Do not operate at low speed for a long time by pressing the switch. Otherwise the machine will be overheating inside.
Change the rotating speed after stop.
Switch lock （see Figure D）
4.
The switch has the lock protection function which helps to avoid the accidental activation of the hand drill. Lock the machine by adjusting
the reversing yoke （ 2） to the center position.
Rotation reversing （see Figure D）
5.
Forward: Push the side of reversing yoke （2） marked with "
Push the side of reversing yoke marked with "
Warning
The rotating speed can only be changed after the machine is completely still.
Installation or removal of bit （ see Figure E）
6.
Caution: When installing or removing the bit, be sure to confirm that the drill has been turned off and that the battery pack has been
removed.
The machine is designed with a quick-loading chuck system.
When installing the screwdriver bit, pull the sleeve forward and insert the screwdriver bit into the chuck. Loosen the sleeve to fix the
screwdriver bit.
When removing the screwdriver bit, pull the sleeve forward and pull the bit out, and then release the sleeve to reset it.
Aviso
Antes do lacionamento da máquina, tenha cuidado para garantir que a cabeça da chave de fenda esteja completamente
fixada pela pinça.
7. Work light
Machine is equipped with the work light: when the switch is pressed, the light will come on; when it is released, the light will go out 15s
later.
51085
" to the end （right side） for releasing or unscrewing the screw the screw.
中文
" to the end （left side） for drilling a hole and driving the screw. Reverse:
EN DE RU KO PT JA ES
19