KTM 61012035044 Manual Del Usario página 12

Starting with the emergency code
NOTE:
– Use the following procedure if no functioning hand-held transmitter is available to deactivate the alarm system.
– This procedure must be repeated each time the engine is started since the engine lock is automatically activated 50 seconds after
the ignition is switched off
– Switch the ignition to ON. The alarm system will trigger an optical and acoustic alarm, the alarm LED will light up
continuously.
– Switch the ignition OFF and watch the alarm LED. The first digit of the emergency code will start to blink (in this case the 2 in
code 26673).
– After the alarm LED lights up 2x, immediately switch the ignition ON and OFF again.
– The alarm LED will blink for the 2nd digit of the emergency start code (the 6 in our example). After the alarm LED lights up 6x,
immediately switch the ignition ON and OFF again.
– The alarm LED will blink for the 3rd digit of the emergency start code (the 6 in our example). After the alarm LED lights up 6x,
immediately switch the ignition ON and OFF again.
– The alarm LED will blink for the 4th digit of the emergency start code (the 7 in our example). After the alarm LED lights up 7x,
immediately switch the ignition ON and OFF again.
– The alarm LED will blink for the 5th digit of the emergency start code (the 3 in our example). After the alarm LED lights up 3x,
immediately switch the ignition ON and leave it on. If the emergency start code was entered correctly, the alarm system is deac-
tivated and you can start the engine.
12