KTM 61012035044 Manual Del Usario página 8

8
1
2
3
4
5
Scope of supply: 1 retaining bracket 60012035150
3 bushings 60012035170
3 cable support sleeves 60012035160
1 M6x12 AH oval-head screw 0738060121
2 M6x10 HH collar screws 0014060103
1 DIN 9021 A6 flat washer,4 0021060003
4 DIN 125 A4 flat washers,3 0125040003
8 DIN 7981 C3 oval-head tapping screws, 5x16 0738060161
1 Reed switch 60012035180
1 LED cable 60012035190
Mounting
– Dismount the seat.
– Dismount the upper left and right rear section.
– Dismount the main silencer.
– Cut the pattern [1] out of the attachment and place it on the lower
rear section.
– Punch at the points indicated [2] and drill (D=6,5mm).
– Mount 2 threaded bushings [3] using the M6x10 collar screws [2].
– Mount the cable support sleeves on the retaining bracket and position
the third bushing [4].
– Position the retaining bracket to determine the center for the hole
(D=6,5mm) [4].
– Remove the retaining bracket and drill the hole (D=6,5mm).
– Drill 2 holes for the Reed switch [5] to position it in the center of the
vehicle flush with the upper edge of the lower rear section. Fasten the
Reed switch [5] with 2 oval-head tapping screws.