STACK-ON PS-1514 Instrucciones página 4

Secure the safe to a wall stud, and to a permanent
shelf or oor, using the predrilled mounting holes in
the safe.
NOTE: e safe must be secured to a wall stud on
one side of the safe in the top and bo om holes in
the back of the safe so that it is anchored to the
wall stud in two locations. Wall anchors should be
used on the other side.
mounted to a permanent shelf or to the oor. Use
the hardware provided or consult your hardware
retailer for fastening hardware for your particular
mounting surfaces.
Mark the holes to be used. Drill the appropriate
diameter and depth of pilot holes depending on
the type of hardware being used and the mounting
surface.
Secure the safe with the fasteners. (Figure 2)
Figure 2
e safe should also be
PS-1514
PS-1515
PS-1415-RTX
PS-1520
PS-1508
MAINTENANCE
Tools Required:
Phillips screwdriver
5mm Allen wrench
If the door of the safe starts to rub on the door
frame, open the door per the instructions above.
By the door hinges you will nd a threaded stem.
Use an Allen Wrench to tighten the threaded stem.
is will realign the door.
IMPORTANT
Keep keys and your combination number in a secure
place, away from children. Keep this record of your serial
number and combination in a secure place separate from
your safe. To order a replacement key set, follow the
instructions on the a ached form.
STACK-ON PRODUCTS CO.
P.O. BOX 489, WAUCONDA, IL 60084
4
18
40531-1506