Install The Grass Catcher; Install The Mulch Plug; Set The Blade Height; Install The Battery Pack - GreenWorks LMF318 Manual Del Operador

3. Tighten the upper handle with the quick-release levers (9)
on the two sides.
Make sure that the two handles are in the same position.
WARNING
Do not make damage to the cables when you fold or unfold
the handle.
7.3

INSTALL THE GRASS CATCHER

1. Remove the mulch plug.
2. Open the rear discharge door (11) and hold it.
3. Hold the the grass catcher by its handle (12) and put the
hooks (13) over the slots (14).
4. Close the rear discharge door.
7.4

INSTALL THE MULCH PLUG

1. Remove the grass catcher.
2. Open the rear discharge door (11) and hold it.
3. Hold the mulch plug (8) by its handle and fit it in the
discharge chute.
4. Close the rear discharge door.
7.5

SET THE BLADE HEIGHT

The machine can be set to different blade heights.
NOTE
English
1. Push the height adjustment button (7), move the height
adjust gear to a higher position to increase the blade
height.
2. Push the height adjustment button (7), move the height
adjust gear to a lower position to decrease the blade
height.
7.6

INSTALL THE BATTERY PACK

• If the battery pack or charger is damaged, replace the
battery pack or the charger.
• Stop the machine and wait until the motor stops before
you install or remove the battery pack.
• Read, know, and follow the instructions in the battery
and charger manual.
1. Open the battery door (6).
2. Align the lift ribs on the battery pack (15) with the
grooves in the battery compartment.
3. Push the battery pack into the battery compartment until
the battery pack locks into place.
4. When you hear a click, the battery pack is installed.
9
WARNING
EN