Manual Navigation (Without Vacuuming); Directing The Robot Vacuum Cleaner To The Base Station; Finishing Vacuuming Manually; Vacuuming Modes - Miele Scout RX1 / 1115 Instrucciones De Manejo

en
Manual navigation (without
vacuuming)
You can use the direction buttons on
the remote control to direct the robot
vacuum cleaner to a specific area of
the room.
^ Press and hold one of the direction
buttons.
The robot vacuum cleaner will travel in
the desired direction without
vacuuming.
You cannot direct the robot vacuum
cleaner manually to the base station
in order to recharge it.
Directing the robot vacuum cleaner
to the base station
^ Press the Base button on the remote
control.
The robot vacuum cleaner will travel to
the base station and recharge. The
base station contact indicator will go
out.

Finishing vacuuming manually

^ Press the Power button on the
remote control.
42
The robot vacuum cleaner will switch
into standby automatically after approx.
60 seconds. The display will be
deactivated. The battery capacity
status indicator will continue to light up.
You can switch the robot vacuum
cleaner into standby before 60
seconds is up by pressing the Power
button again.
The robot vacuum cleaner is
reactivated by pressing any button on
the remote control or one of the two
sensors in the robot vacuum cleaner
display.

Vacuuming modes

There are four different vacuuming
modes.
Auto Standard vacuuming mode
for vacuuming normally
soiled flooring.
Spot For targeted vacuuming of a
surface approx. 1.8 m x 1.8 m
around the selected starting
point of the robot vacuum
cleaner.
Corner For vacuuming normally
soiled flooring (see Auto).
Additional edge vacuuming
after returning to the starting
point.
Turbo For vacuuming lightly soiled
flooring with a short
vacuuming duration.