Frequently Asked Questions (Faqs) - Marmitek MegaView 141 UHD Modo De Empleo

7

Frequently asked questions (FAQs)

No (or poor) image and sound
If you experience poor or no picture after connecting the MegaView 141 UHD™, try
detecting the problem by connecting the devices to your TV or projector one at a time.
This enables you to determine whether the problem is in the HDMI sources, the HDMI
cables, the MegaView 141 UHD™ or the TV.
x
Make sure the power adapter is connected and plugged in.
x
For the best picture and sound quality, only use High Speed HDMI® certified
cables.
x
Do not use HDMI cables longer than those specified in the technical data.
x
Check the HDMI cables and/or connectors for damage.
x
Both the HDMI source and your TV or projector should fully support HDMI.
x
Check that your HDMI sources and TV or projector support HDCP 2.2 (High
Bandwidth Digital Content Protection) copy protection.
No (or poor) image and sound
x
Please check that the HDMI source is switched on.
x
Only use CAT5e/CAT6 cables, as specified in section 4. Requirements.
x
Make sure that the CAT5e/CAT6 cable is connected well (no breakages).
x
Make sure the RJ-45 is connected according to the EIA/TIA T568B standard.
x
Make sure that the maximum cable length is not exceeded.
x
Prevent installing your system close to RF sources (wireless devices) as much as
possible.
x
Set your HDMI source to a lower resolution, the CAT5e/6 cable used may not be
able to handle the bandwidth of higher resolutions.
Do you have any questions that are not answered here? Then please visit
www.marmitek.com
MEGAVIEW 141 UHD™
13