Operating Your Freezer; Temperature Control; Defrosting Your Freezer - Avanti CF24Q0W Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Temperature Control

Your freezer has one control for regulating the temperature. The temperature control is located
on the lower right hand corner.
The first time you turn the unit on, switch the temperature control to the position number 7 and run
for at least 2 hours before putting frozen foods inside. This will ensure the cabinet is thoroughly
chilled before food is put in.
The range of the temperature control is from position "1" the warmest to "7" the coldest. Adjust the
temperature control to the setting that best suits your needs. The setting of "4 or 5" should be
appropriate for home or office freezer use.
To turn the freezer off, unplug the unit from the electrical outlet.
NOTE:
If the unit is unplugged, lost power, or turned off; you must wait 3 to 5 minutes before restarting
the unit. If you attempt to restart before this time delay, the freezer will not start.
Large amounts of food will lower the cooling efficiency of the appliance.
If you choose to change the thermostat setting, adjust thermostat control by one numerical
increment at a time. Allow several hours for temperature to stabilize between adjustments.

Defrosting Your Freezer

• When? For the most efficient operation and minimum energy consumption, defrost the freezer
when the frost on the freezer walls is excessive or ¼ to ½ inch thick.
• Choose a time when the stock of frozen food is low.
CAUTION
Do not use boiling water because it may damage the plastic parts. In addition, never use a
sharp or metallic instrument to remove frost as it may damage the cooling coils and will void
the warranty. We recommend using the plastic scraper provided with your unit.
Remove the frozen food from the freezer and place it in a cooler to protect the food.
Unplug the freezer. The Power Supply light should be off (red light out).
During defrosting, the ice melts into the cabinet.
Remove the drain plug on the inside floor of the freezer by pulling straight out.
Place a shallow pan outside drain outlet. The defrost water will drain out.
Check the pan occasionally so the water does not overflow.
Clean the interior of the freezer.
Replace the plug on the inside floor.
Reset the thermostat to desired setting.
Allow the cabinet to cool for two hours.
Return food to the freezer.
HELPFUL HINT:
Defrosting usually takes a few hours. Leaving the door open will help speed the process.
Also, pouring warm water (not boiling) on the ice/frost will help speed melting. If you must
use a scraper- please use caution - it is very easy to damage the freezer compartment and
void your warranty.

OPERATING YOUR FREEZER

9

Publicidad

Tabla de contenido
loading

Tabla de contenido