JENN-AIR PRO-STYLE PRG3000P Guia Del Usuario página 6

S
C
URFACE
S B
URFACE URNERS
NOTES:
• All burner ignitors will spark when
any surface burner is turned on.
• Surface burners may be difficult to
light at times due to air in the gas
line. This may occur:
a) during installation
b) if range is disconnected from
the main gas supply
c) if the appliance has not been
used for several days
To remove air in the gas line,
hold a lighted match next to the
burner head and turn the control
knob on.
• The burner flame may appear sepa-
rated from the port, if a pan is not
placed on the grate.
Your range is equipped with three-part
burners. The center caps cover the low
flame settings from boilovers. These caps
also spread the flame out to avoid too much
heat in pan centers.
LO FLAME
INNER CAP
PORTED BURNER RING
The burners have a solid state ignitor.
When the control knob is turned on, gas
will flow into the burner and the ignitor will
spark to light.
A properly adjusted burner with clean ports
will light within a few seconds. The flame
will be blue with a clearly defined inner
cone. There should be no trace of yellow in
the flame. A yellow flame indicates an im-
proper air/gas mixture and should be ad-
OOKING
justed by a service technician. (During ini-
tial use, dust in the line or in the air may
briefly cause an orange flame.)
T S
O ET
1. Place a pan on the burner grate.
2. Push in on the control knob and turn the
knob counterclockwise to the Lite set-
ting. A clicking sound will be heard until
the burner lights.
C
ONTROL
All burners have a 15,000 BTU rating on the HI setting.
1. Left front surface burner.
2. Left rear surface burner.
3. Center front surface burner.
1. Left front surface burner.
2. Left rear surface burner.
C
ONTROLS
L
OCATIONS
MODEL PRG4802P
MODEL PRG3601P/PRG3000P
5
CAUTION:
If the flame should go out during a
cooking operation, turn the burner off.
If a strong gas odor is detected, wait 5
minutes for gas odor to disappear be-
fore relighting the burner.
4. Center rear surface burner.
5. Right front surface burner.
6. Right rear surface burner.
3. Right front surface burner.
4. Right rear surface burner.