Vaude Space L 3P Manual Del Usuario página 17

ENGLISH
them into each other. Do not whip out the pole sec-
tions so they snap together. Make sure that each
pole section is fully inserted into the next section;
otherwise they may crack or break under pressure.
Gently slide the poles through the pole sleeves. Do
not pull them through.
3. Erect the tent and make sure that the entrance zip
is not under undue tension or strain which could
easily damage the zip. Use the releasing lock at
the bottom of the entrance.
4. Stakes should be driven in at a 60° angle away
from the tent (X).
5. In the event of strong winds or a storm, it is
necessary to additionally secure the tent with the
attached storm cords. To adjust the length of the
storm cord, push the Stormcord Collector up or
down. If the storm cord is not required, wrap the
cord around the Stormcord Collector and secure
the end on the hook provided for this purpose (V).
6. The VAUDE Y-stakes that come with our tents
are very durable and resistant to bending and
especially suited for hard ground and grass. For
extremely hard ground, we recommend the use
of tent pegs or spikes. VAUDE offers special stakes
for very soft ground, snow or sand. Hammer them
in vertically for soft soil or bury them horizontally
to anchor in sand or fresh powder snow (Y).
SeTTing Up – "MODeL­Specific":
Please follow these instructions.
1. Clear the ground of any sharp objects (We recom-
mend the use of an optional groundsheet protec-
tor).
2. Lay out the inner tent on the ground.
3. Lay out and assemble the poles (a): they consist of
2 long main poles (a1) and two short (a2).
4. Insert each of the long poles into a sleeve (a, B).
Then insert poles into the relevant sockets at the
bottom and tension (c).
5. Slide the two hood poles (a2) into the hood sleeves
(D) and push the ends into the associated sockets.
(e). assembly of inner tent only: Detach the ou-
ter tent from the inner tent. Thread the long poles
through the inner tent loops, then push into the
10