Makita LS1214 Manual De Instrucciones página 21

1
2
3
(2) 45° bevel angle
1
2
Adjust the 45° bevel angle only after perform-
ing 0° bevel angle adjustment. To adjust left
45° bevel angle, loosen the lever and tilt the
blade to the left fully. Make sure that the
pointer on the arm points to 45° on the bevel
scale on the arm holder. If the pointer does
not point to 45°, turn the left 45° bevel angle
adjusting bolt on the side of the arm holder
until the pointer points to 45°.
To adjust right 45° bevel angle, perform the
same procedure described above.
Adjusting for smooth beveling action
1
The hex lock nut holding together the arm and arm
holder has been factory adjusted to assure smooth bev-
eling action and to guarantee precise cutting. Do not
tamper with it. Should looseness develop at the arm and
arm holder connection, tighten the hex lock nut using a
wrench.
001572
1. Bevel scale
2. Screws
3
3. Pointers
001573
1. Arm holder
2. Right 45° bevel
angle adjusting
3
bolt
3. Left 45° bevel
angle adjusting
bolt
004860
1. Arm
2
2. Hex lock nut
Adjusting the position of laser line
For model LS1214L only
1
3
1
2
WARNING:
• As the tool is plugged when adjusting the position
of laser line, take a full caution especially at switch
action. Pulling the switch trigger accidentally cause
an accidental start of the tool and personal injury.
CAUTION:
• LASER RADIATION
Do not stare into beam.
• Never apply a blow or impact to the tool. A blow or
impact causes the incorrect position of laser line,
damage to the laser beam emitting part or a short
life of the tool.
When adjusting the laser line appears on the left side
of the saw blade
1
1. Screw to change the
movable range of the
adjusting screw
3. Hex Wrench
5. Saw blade
21
006342
1. Workpiece
2. Cutting line
3. Holder
2
006343
1. Vertical vise
2. Holder
2
4
3
2. Adjusting screw
4. Laser line
006345
5