Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLING THE WM40-L
AND WM40-R IN THE PER-
FORMER SPEAKERS
1. Unscrew the module cover (on the top-right,
while facing the rear of the speaker) on the
Performer speaker.
2. Slide the WM40 module into the socket.
3. Use the provided screw to fasten the WM40
module to the Performer speaker.
4. Use sticky – tape to attach the 2 antenna
wires to the rear-inner wall of the module
slot, ensuring they do not cross one another.
This will allow for greater quality of recep-
tion.
5. Replace the module cover.
0
WM400(D) RECEIVERS
These wireless receivers can be used in con-
junction with any active speaker. The receiver
can be attached to the speaker by screwing it
into the stand's screw socket.
1. 4 Digit Display(WM400D-L and WM400D-
R only) – This display will allow users to
see the properties that are currently in use
by the WM400D, whether you are adjust-
ing the receiver channel (indicated by CH),
the EQ settings (indicated by EQ), the de-
lay time (indicated by only the delay time
in milliseconds) or the high and low pass
filters (indicated by a H or L, respectively).
This display will light up when the device is
turned on.
2.
AF
Indicators
– When this LED
is illuminated, it in-
dicates that there
is an audio signal
being received by
the WM400(D) re-
ceiver.
3. RF Indicators – When the RF indicator il-
luminates, it shows that the transmitter's
signal is being received successfully. If for
some reason this LED does not turn on,
check your DC power input and pre-set
channel configuration and try again.
4. Bypass Indicator( only for
and WM400D-R) - this LED will light up
when the digital processing feature of the
WM400(D) receiver is off.
5. Power Button – hold this button down for 2
seconds to power up the unit.
5
7
6
2
3
4
WM400D-L
5
WM SERIES
Publicidad
