Publicidad
Idiomas disponibles
Idiomas disponibles
4. Stereo/Mono Selector – This will allow
users to change the wireless signal sent
from the WM70 to be alternated between
a mono and stereo signal.
5. On/Off Button – this button turns the
WM70 on and off. An LED will illuminate
under this button when it is on.
Rear Panel
6. Left and Right Combo Input – this jack
accepts both balanced and unbalanced
/4" and XLR inputs from line-level sources
(such as the main output of a mixer).
7. Left and Right Antennas – this for the in-
sertion of the WM70's left and right anten-
nas. Insert the antennas and adjust them
to sit in a vertical position when the device
is in use. Screw the antenna in to lock it
into place.
8. DC In – plug DC end of the supplied DC
power adaptor into this jack, and the other
end into a suitable AC power source to al-
low the WM70 to be powered. Please en-
sure you use the DC power supply (2V,
750mA) provided with this unit, as using
another power supply could cause dam-
age.
WM SERIES
WM40-L AND WM40-R
RECEIVERS
Insert the wireless receivers into the Active
Performer Speakers to allow them to receive
signals sent by the wireless transmitters.
These modules should be inserted and fixed
into the right hand side (when facing the rear
of the speaker) compartment at the top of
the speaker, and screwed into place with an
M3x4 screw.
1
1. Channel Selector- adjusting this dial to one
of the preset channels allows the WM40 to
know which frequency to look for the wire-
less information. The wireless transmitter
should be set to the identical channel if
transmission is to occur successfully.
2. On Indicator– this LED indicator illumi-
nates when the WM40 Receiver is pow-
ered.
3. Antenna– The wireless receiver's antenna
comes in the form of 2 small wires protrud-
ing from the casing. When you insert the
module into the appropriate slot on the
Performer speaker, it is best to sticky-tape
the antennas to either side of the compart-
ment wall.
IMPORTANT
Whenever using the WM40L or WM40R,
the included short pin should be inserted
into the unused wireless microphone mod-
ule slot to enable the wireless module to
be used.
3
2
9
Publicidad
