Descargar Imprimir esta página

Phonic WM Serie Manual Del Usuario página 7

Kit inalámbrico para altavoces activos

Publicidad

Idiomas disponibles

Idiomas disponibles

Dual Channel Setup
Users are able to wirelessly send ste-
reo signals through the WM70 transmitter
and WM40-L / WM40-R or WM400(D)-L /
WM400(D)-R receivers.
1. Plug the mixer's main stereo output (with a
line-level signal) to the left and right inputs
(both XLR and  /4" inputs can be con-
nected to the combo-jacks) of the WM70
transmitter.
2. Connect the provided DC power supply to
the WM70's and WM400(D)'s power input
and an appropriate AC power source.
3. Adjust the channel on the WM70 and both
WM40s/ WM400(D)'s so they are identical.
If you wish to send and receive a signal
successfully, this is of utmost importance!
4. Make sure the WM70 is switched to "ste-
reo" mode.Turn the left and right level con-
trols to around 3 o'clock position.
5. SYS2: Insert the left and right antennas
into the left and right antenna plugs on the
WM70, and leave them sitting vertically for
the best range.
WM40-L & WM40-R is inside the
slot of Phonic Performer speaker
WM-SYS2: Dual Channel Setup
WM SERIES
SYS4: Attach the WM400(D) to your active
speaker by the included M6, M8 and M0
screws or velcro strip.Connect appropri-
ate audio cables to the WM400(D)s' XLR
outputs and your speakers' inputs.
6. SYS2: You can then insert the WM40-L and
WM40-R receiver modules into the Phonic
Performers' wireless module receptacles
on the top right hand side (when facing
the rear of the speaker) of the speakers
(Use the WM40-L on your left speaker, the
WM40-R on your right). Move the modules'
antennas (protruding from the case) and
tape them to each side of the module slot.
7. SYS2/SYS4: Set the WIRELESS / WIRE-
LESS MIC switch on the rear panel of the
Phonic performer speaker to the "Wire-
less" Position, and set the wireless volume
control to around 3 o'clock position.
8. Turn the WM70 on first, then the Performer
Speaker.
9. Provided you have a signal going out of
your mixer, and your Speaker is turned on,
the wireless transmission should be work-
ing.
WM400-L
WM70
WM-SYS4: Dual Channel Setup
Any active speaker
WM400-R
7

Publicidad

loading

Productos relacionados para Phonic WM Serie

Este manual también es adecuado para:

Wm40-lWm40-rWm60Wm70Wm400-lWm400-r ... Mostrar todo