Maintenance; Troubleshooting; Repairs - ROTOR Vitamat INOX RVI 2 Manual De Instrucciones

Grossküchen- und Bäckereimaschinen
CH-3661 Uetendorf

10. MAINTENANCE

- The motor bearings are permanently lubricated and therefore require no maintenance.
- The grating disc wears out and has to be replaced at least annually.

11. TROUBLESHOOTING

PROBLEM
The appliance doesn't run
Grinding noise
Too much force needed to pushfood
down with plunger, vegetables and
fruit not neatly cut
The appliance only vibrates with the
mounted centrifugal basket
Very noisy (testing without the
centrifugal basket!)

12. REPAIRS

Obtain the address of your nearest Rotor Lips authorized service center from the store
where you purchased your appliance.
When returning the unit for repairs use a shockproof packing and well upholster the
machine!
Repairs on electrical appliances should only be carried out by
professional technicians. Serious dangers to the user could result from
improperly carried out repairs.
Attention!
If the appliance's mains cable should become damaged, it can only
be replaced with an original cable.
Instruction Manual
Rotor Vitamat INOX
CAUSE / SOLUTION
- Make sure the mains cable is plugged into
a wall socket
- The safety clasp is properly closed
- Press the appliance switch off
and press again
- Check the fuse in the applicable building
electrical circuit
- see chapter „Safety features and protection"
(motor protection switch)
- The maschine was not correctly put together.
Please refer to chapter „Operating
intructions"
- grating disc are dull. Replace grating disc
in centrifugal basket
- Pulpe chute is clogged
- The centrifugal basket is deformed or dirty
- Motor or electronics is defective. Immediately
stop the machine and get it repaired
© Rotor Lips AG
27