Jump-N-Carry JNCAIR Manual Del Usuario página 6

Air Compressor Instructions
1. Remove valve stem cap and connect compressor hose to the valve stem.
2. Turn on the air compressor and use the gauge to monitor the tire's pressure.
3. Once the tire has reached the appropriate PSI (noted on the tire or in the Owner's
Manual), turn off the compressor.
4. Disconnect the compressor hose and return to storage clip. It is always good
practice to test the tire pressure with an independent and properly calibrated tire
gauge.
5. Replace valve stem cap.
NOTE: The Jump-N-Carry air compressor features an overheating protection
switch that could result in a temporary shut-down of the air compressor while in
use, if recommended operating temperature is exceeded. After cooling, the air
compressor will reset itself and resume normal operation.
Your air compressor is equipped with a permanently lubricated, maintenance free motor.
Never try to lubricate the compressor.
Regularly clean dust and dirt from the compressor cooling fins.
Your Jump-N-Carry is an essential tool for all who replace automobile batteries.
Most vehicles have electronic components with memory, such as alarm systems,
computers, radios, phones, etc. and when the vehicle's battery is replaced, the memory
is lost. However, if the Male-Male Extension Cord is connected from the Jump-N-Carry
to the 12 Volt outlet on the vehicle, the memory can be saved.
Note: To use the Jump-N-Carry for this purpose, the chosen outlet must be live when
the vehicle is turned OFF. On some vehicles, 12 Volt outlets are deactivated when the
vehicle is turned OFF.
Your Jump-N-Carry is also a portable power source for all 12 Vdc accessories equipped
with a male 12 Volt plug. The DC outlet on the Jump-N-Carry has automatic overload
protection.
When your Jump-N-Carry is used with a DC to AC power inverter, it can operate
appliances normally powered by 120 Vac or 220 Vac. Recommended inverter for the
portable power source is 300 watts maximum. For more information, contact your
nearest Jump-N-Carry dealer.
Performance and Temperature
Performance of your Jump-N-Carry will depend upon several factors:
• A good, solid connection between the Jump-N-Carry clamps and the battery
and ground connections are a must. Moving the clamps back and forth while
connecting to the battery will help create a better connection.
• Clean connections between your vehicle or equipment battery and its terminals are
very important. For an optimal connection, corrosion (soft grayish-white build-up)
on battery terminals must be removed. With the ignition turned off, disconnect the
battery cables and clean the terminals and battery posts with a baking soda solution.
12 Volt DC Power