Using The Machine - Garland SIOUX 1455 ZSL Manual De Instrucciones

6.4. STOPPING THE ENGINE
Turn of the engine by releasing the safety switch.
6.5. TRACTION DRIVE
Press the traction handle against the handlebar, as
shown in the figure, and the mower traction will start
operating.
6.6. CHECKPOINTS AFTER STARTING THE
MACHINE
It is important to pay attention to the possible
individual parts or and the temperature of the
machine. If you detect any anomaly in the machine
immediately stop and check it carefully.
In case of any malfunction or problem take the
machine to a service technician to be repaired.
Under no circumstances must you continue to
use the machine if the operation does not seem
appropriate.
Do not use the machine if it is damaged or
improperly adjusted.

7. USING THE MACHINE

Use this machine only for the designated
purposes. Using this chainsaw for any other use
is dangerous and can cause bodily harm and/or
damage to the machine.
Do not start the machine in a room or
enclosure. The exhaust gases and fuel
and oil vapors contain carbon monoxide
and harmful chemicals. In case of a concentration of
gases produced by poor ventilation, remove all that
impedes the flow of clean air to improve ventilation
from the work area and not return to work in the area
unless you have properly ventilated area and have
clear that ventilation is sufficient so that does not
happen this concentration again.
Work only in daylight or good artificial light. Do not
use this machine at night, with fog or with a low
visibility which do not allow you to clearly see the
working area.
Whenever possible, avoid using this machine when
the ground is wet. Pay special attention if you use
this machine when it is raining or after it has rained,
as the ground will be slippery and you could slip
and fall.
47/184
English