Assembly - Truper CANT-6X-2 Manual Del Usuario

• Before assembling the tool unscrew the packing pallet from the cabinet base.
• Place the machine in a well-leveled floor and strong enough to support the weight. Assemble in the place where it will
be operated. Use wedges to level the tool in the event of wobbling. The space shall have good lighting and ventilation.
• The machine includes all the nuts and bolts necessary to assemble. Also it has a set of Allen hex keys and an open-end
wrench with the measurements needed to assemble.
Cabinet
CAUTION
The pulleys shall be aligned to the same depth. If
necessary the adjustment can me done pushing or pulling the motor
pulley (B) loosening before the screw securing the motor axis. Also,
the motor can completely be pushed or pulled loosening the screws
attaching it to the cabinet.
After adjusting tighten the screws.
4
E
Assemble the pulley guard (E) in the
Jointer using four sets of screws, washers
and pressure washers.
6
ENGLISH
Work table
Motor

Assembly

Step
Set the work table onto the cabinet.
CAUTION
carried out with two people at least.
Secure the work table to the cabinet with
three hexagonal screws with washers.
C
2
Set the motor pulley belt
(B). Pass the belt through
the upper orifice in the
cabinet and set one side
of the band in the cutter
head pulley (C).
3
Loosen the four screws (D) to raise or lower
the motor until the belt is tense. Then,
tighten the screws.
Assemble the rip fence (F) to the pulley
guard using two sets of screws, washers
and pressure washers.
1
This operation shall be
Cutter
head
B
D
F
5