HAMPTON BAY Havana Guía De Uso Y Cuidado página 11

Assembly - Attaching the Light Kit
11
Attaching the light kit
CAUTION: To reduce the risk of electric shock, disconnect
the electrical supply circuit to the fan before installing the
light fixture.
□
Remove the four screws on the black bracket of the fan-
motor assembly (D).
□
Connect the wires exiting the bottom of the black bracket
with the light kit fitter assembly by connecting the molded
adaptor connectors together.
□
Secure the light kit fitter assembly to the black bracket using
the four screws that were removed in the first step above.
12
□
□
□
□
□
D
E
I
11
Installing the bulbs and attaching
the glass bowl
Remove the rubber washer, hex nut, and finial from the light
kit fitter assembly.
With power off, install the three LED bulbs (K) (Max. 9.5W,
included) by screwing into the light bulb sockets.
Position the glass bowl (I) over the threaded nipple and pass
the pull chain (FF) for the fan through the pull chain guide on
the side of the light kit fitter assembly to avoid the chain from
touching the glass bowl.
Re-install the rubber washer and hex nut to the threaded
nipple to secure the glass bowl (I) properly.
Re-install the finial.
CAUTION: Do not over tighten the hex nut, overtightening the
hex nut may cause the glass to break.
K
FF
NOTE: Notice the location of the fan's slide switch. This is the
switch used to change the fan's directional rotation. For more
information on the operation of this switch, see Operating Your
Fan and Remote Control on page 12.
Please contact 1-855-HD-HAMPTON for further assistance.
HAMPTONBAY.COM