SEVERIN KS 9770 Instrucciones De Uso página 18

– The packaging materials must be properly disposed of.
– NOTE: When the door to the freezer unit is opened, a small red component will fall out; this is
for transport only and can be disposed of.
– Fit the two spacer elements (provided) into the corresponding guide
slots on the rear.
– Before it is connected to the mains, the unit must be thoroughly
checked for transport damage, including its power cord.
– Clean the unit as described in the section De-frosting and cleaning.
– For positioning, we recommend that you tilt the unit slightly
backwards. In this way, the transport rollers can be used to move it to its intended place of
installation.
– The unit should only be transported in its vertical position; do not tilt any more than 30°.
– Once the unit has been positioned, wait for about 30 minutes before it is connected to the mains.
– If the unit has been tilted more than 30° during transport, allow it to stand upright for at least 4
hours before it is connected to the mains.
– When the unit is first switched on, a slight 'new' smell may be noticed. However, this will
disappear once the cooling process has begun.
Installation
 The appliance should be set up in a well-ventilated, dry room.
 It should be operated in conditions where the relative humidity is no more than 70 %.
 The product data sheet contains details of the ambient temperature range suitable for this
appliance.
 Do not use the appliance outdoors.
 Ensure that the plug is accessible and can be removed from the wall socket at any time.
 Do not expose the appliance to direct sunlight, and do not position it next to any heat sources
(radiators, cookers etc). If this cannot be avoided, however, suitable insulation must be in installed
between the heat source and the unit.
 The unit must not be installed inside a cabinet, nor directly below a hanging cupboard, shelf or
similar object.
 In the case of uneven floors, the adjustable feet on the unit can be used to compensate and ensure
optimum stability.
Set-up dimensions
18
Ventilation