Publicidad
Idiomas disponibles
Idiomas disponibles
Operation
Warnings & Precautions
Hoist operators should read and fully comprehend this entire manual and all warnings on the hoist before
beginning hoist operation. If this manual is not read and followed completely injuries may occur.
Operator Requirements:
Read and fully comprehend this entire manual before hoist operation.
Must be trained in proper hoist operation and dealing with potential malfunctions.
Should not operate hoist while under influence of alcohol, medications, or drugs. Should not operate the
hoist while tired or distracted.
Should not operate hoist if they have a history of seizures or other medical issues that may interfere with
hoist operation.
Should have proper coordination and vision.
Prior to Operation be sure:
Hoist is clean and properly lubricated.
Hoist is in proper working condition and maintenance records are up to date.
Brake is functioning properly.
Area of operation is clear of flammable materials.
During Hoist Operation:
Maintain secure footing to prevent slipping and injury while operating.
Confirm that hoist unit is attached securely to a support before operation.
Verify hook latches are not supporting any of the load.
Do not hold the chain during hoist operation.
Slowly take up the load, verifying it is well supported and balanced before proceeding.
Lever Hoist Operation
Free Chain Operation- Allows the unloaded hook to be moved to the desired position by hand in order to
attach the load.
1. Place the selector to the Neutral position.
2. Pull the load chain to the desired position to attach the load.
3. To disengage the free chain operation, move the directional lever to the (up) or (down) position.
4. Pull the unit in both directions to assure it is out of free chain mode.
Attaching the Load
1. If there are no twists in the chain proceed on to attach the lower hook to the load.
2. Do not use the chain to wrap around the load.
3. The load should be seated in the bowl of the hook and should not bear against the tip
of the hook or latch.
4. The hook latch should be tightly closed against the hook tip
5. Assure that the upper and lower hooks form a straight line and frame is able to swivel.
EN pg.9
Publicidad
