Connecting Cables - Eizo FlexScan S2401W Manual Del Usuario

Prior to use

Connecting Cables

Attention
• When replacing the current monitor with a S2401W monitor, be sure to change the PC settings for
resolution and vertical frequency to those which are available for the S2401W monitor referring to the
resolution table (back of cover page) before connecting the PC.
NOTE
• When connecting two PCs to the monitor, refer to the User's Manual on the CD-ROM.
1
Check that the monitor and the PC are powered off.
2
Connect the monitor to the PC with a signal cable that matches the connectors.
After connecting the cable connectors, tighten the screws of the connectors to secure the coupling.
CD player, etc
Connectors on
the PC
Audio output
connector
DVI connector
D-Sub mini 15-pin
connector
3
Plug the power cord into a power outlet and the Power connector on the monitor.
Adjusting Screen Height and Angle
Hold left and right edge of the monitor with both hands, and adjust the screen height, tilt and swivel of the screen to the
best condition for working.
Height adjustable stand
Hold left and right edge of the monitor with both hands to
adjust the screen up, down, left and right directions.
4
Installation Setting/Adjustment
Stereo mini jack cable (supplied)
Signal cable FD-C39 (supplied)
Digital connection
Signal cable MD-C87 (supplied)
Analog connection
EZ-UP stand
Hold the left and right edges of the monitor with both
hands and adjust the screen angle by moving them
upwards, downwards, or to the left or right.
Troubleshooting
Connectors on
the monitor
Audio input
connector
DVI-I connector
D-Sub mini 15-pin
connector