User Keypad Operation - Kohler K-1360 Manual Del Usuario

Rotate outer ring to
access desired mode.
Power On/Off
Chromatherapy-Specific Color
(H2 models only)

User Keypad Operation

Power - Turns the whirlpool pump on and off. Symbols illuminated in blue indicate available
modes/features. Modes which are operating will be illuminated in green.
Outer Ring - Rotate the outer ring to the desired mode. The selected mode will flash (blue).
Activate Button - Press "OK" to activate the desired mode.
Up Arrow - Increases the water flow when the Flexjet mode is active. Increases the pulse speed
when the neckjet or backjet mode is active.
Down Arrow - Decreases the water flow when the Flexjet mode is active. Decreases the pulse speed
when the neckjet or backjet mode is active.
Flexjet Mode - When active, this mode allows you to adjust the water flow to the eight Flexjets by
pressing the up or down arrows.
Waterfall Mode - When active, a continuous stream of water flows behind your neck. You may
adjust the flow volume by pressing the up or down arrows.
Whitewater Mode - When active, the two outside Riverjets behind your neck will operate, and you
may adjust the flow volume by pressing the up or down arrows.
Rapids Mode - When active, all four Riverjets behind your neck will operate, and you may adjust
the flow volume by pressing the up or down arrows.
Tidepool - This feature turns off the air flow to the jets for a soothing, relaxing effect. The Tidepool
feature may be used at any time while any of the jets are operating. The Tidepool mode does not
affect the Waterfall.
Chromatherapy Cycle (H2 Models Only) - Chromatherapy lights will automatically and
continuously cycle through the eight colors: white, violet, indigo blue, aqua blue, green, yellow,
orange, and red. One cycle through all eight colors takes approximately one minute.
Chromatherapy Specific Color Selection (H2 Models Only) - When this mode is selected, you may
choose a specific color for the bath.
Heater - The heater automatically engages when the whirlpool is turned on. To turn the heater off,
rotate the outer ring until the heater mode is flashing and press "OK". Press "OK" again to turn the
heater back on. The heater will help to maintain the water temperature up to 104° F (40° C).
Indicator Bar - Shows the water flow volume in the Flexjet mode. Shows the pulse speed in the
neckjet or backjet mode.
1022211-5-C
Flexjet Flow Mode
Activates Mode
Selected
Waterfall
Mode
Lighted User Keypad
Riverjet Whitewater Mode
Increases Flow
Riverjet Rapids Mode
Indicator Bar - Shows
water flow volume
Tidepool
Decreases Flow
Chromatherapy Cycle
(H2 models only)
Heater On/Off
6 Kohler Co.