Remote Control; Fcc Compliance; Programming The Remote Control - Kohler K-1360 Manual Del Usuario

Activates Mode
Selected
Mode Selector

Remote Control

The remote control places the whirlpool functions at your fingertips to further enhance your bathing
experience. The functions of the remote are identical to the user keypad. You may turn the whirlpool on and
off, turn the heater on and off, and access/modify all whirlpool functions.
The mode selector button functions in the same way as the outer ring. When "M" is pressed, one of the
modes will flash on the user keypad. If "M" is pressed again, the next mode in clockwise order will flash.
When the desired mode is flashing, press "OK" to activate it.
When the Flexjets, Waterfall, Whitewater or Rapids mode is active, the arrows will increase or decrease the
water flow volume.
The waterproof remote control is designed to be used in the bath and will float in the water.
Two AAA batteries are used in the remote control. To replace, simply unscrew the end cap and insert the
batteries, as shown above. Tighten the end cap securely, making sure the end cap makes contact with the
seal.

FCC Compliance

FCC ID : N82-KOHLER001
Canada ID : 4554A-KOHLER001
Compliance Statement (Part 15.19)
This device complies with Part 15 of the FCC Rules and with RSS-210 of Industry Canada. Operation is
subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired
operation.
Warning (Part 15.21)
Changes or modifications not expressly approved by the party responsible for compliance could void the
users authority to operate the equipment.

Programming the Remote Control

NOTE: Programming of the remote control is normally not required. If more than one device in your
home, or in the near vicinity of your home, uses a remote control, it may be necessary to program this
remote control to the user keypad. If you replace your remote control, or replace the pump control, it may
be necessary to program the remote control.
Turn the whirlpool power on.
Kohler Co.
Power
Increases Flow
Decreases Flow
9 1022211-5-C