Master Appliance Varitemp VT-750C Manual De Instrucciones página 8

Typical Applications
4) When the task is
completed, move rocker
switch to "Cool" position.
Allow blower to operate for
a few minutes on cool.
Shrinking Tubing
Use stand to free both hands.
Slide tubing over area to be
insulated. Place in air stream
and move with a side to side
motion until tubing has
shrunk. Remove from air
stream.
Shrinking Packaging
After shrink wrap has been
sealed around product, poke
a small hole in it to allow
(cont'd)
trapped air to escape. Then
wave heated air stream back
and forth across package until
shrink wrap has evenly
shrunk.
Removing Floor Tile
Direct heated air stream at tile
to be removed in a back and
forth motion. This will soften
the adhesive backing. Place
putty knife under tile and lift to
remove.
Bending and Forming
Plastics
Experiment with a piece of
scrap material first to develop
a proper technique. Place
plastic piece into a proper
holding fixture. Wave hot air
along the whole length of the
"Bend" line until plastic
softens along that area. Bend
plastic to desired position.
Removing Old Putty
When removing putty from a
broken window, carefully
remove the broken glass first.
When removing putty from an
undamaged window, direct
the hot air stream away from
the glass to prevent cracking
due to thermal shock. It is
convenient to shield the glass
from the hot air with a large
putty knife. Wave the hot air
stream at putty until softened.
Remove with putty knife.
8