Wintering Procedure - Teuco 630 Manual Del Usuario

EN

WINTERING PROCEDURE

Empty the minipool completely, as follows:
1. Isolate the minipool from the power supply at the
control panel.
2. Open the discharge valves on the spa pumps
(if the pumps are not fitted with discharge
valves, partly loosen the ring nuts), on the
compensation tank, on the pipes connecting the
pool and the spa-pack and on the D60 piping
inside the pool (if fitted).
3. Drain the water from the filter pump by undoing
the plug at the bottom of the prefilter basket.
4. Remove water lying on the bottom of the pool,
using a wet vacuum cleaner.
5. Cover the minipool with the canvas provided, so
that it will not collect dirt.
Before using the Teuco Minipool again after
the winter break, repeat the steps indicated for
STARTING UP FIRST TIME.
If the pool is to be used during winter, it will
be good policy to lag the overflow tank and all
pipelines with suitable insulation.
SAND FILTER
Empty the filter of water by removing the external
drain plug. This will ensure that water only runs off,
and not the sand, which is retained by the drain outlet
filter.
CARTRIDGE FILTER
Empty the filter of water by removing the external drain
plug (5).
The cartridge must be removed from the housing,
cleaned, and stored in a dry place.
52
1
2
3
630