Insert Hose - Workshop WS0400SS0 Manual Del Usuario

WET/DRY VAC ASSEMBLY (continued)
Power Head Assembly
1. Line up front of power head assembly
with vacuum port located on the front
of the drum, as shown.
2. Place power head assembly on top of
drum.
3. Be sure lid completely covers the top
of the drum so leakage does not
occur.
4. Push down on top of the drum latch
areas to cause the flexible locking tabs
to hook onto the drum channel.
5. Make sure that the locking tabs are
snapped in place to prevent the lid
from coming off (See inset).

Insert Hose

Insert the release button end of the
Locking Hose into the inlet of the Vac.
The hose should snap into place.
To remove the hose from the Vac, press
the release button in the hose assembly
and pull the hose out of the Vac inlet,
as shown.
8
Power Head
Assembly
Drum
Latch (2)
Drum
Vacuum
Port
Release
Button
Hose