Cleanup - WAGNER CONTROL PAINTER Manual De Usario

CLEANUP

For a video showing cleanup of the Control Painter, visit:
i
www.wagnerspraytech.com/controlpainter
CLEANUP NOTES
When cleaning, use the appropriate cleaning
i
solution (warm, soapy water for water-based
coatings, and mineral spirits for oil-based
coatings.
Special cleanup instructions for use with
flammable solvents (must have a flashpoint
above 100ºF (38ºC):
•
Always flush spray gun outside.
•
Area must be free of flammable vapors.
•
Cleaning area must be well-ventilated.
•
Do not submerge turbine!
For basic quick-cleaning between color
i
changes, fill the material container with
cleaning solution and spray the cleaning
solution through the gun and into a waste
container.
1.
Turn turbine OFF. Separate the turbine from the nozzle.
Remove the container and empty any remaining material.
Thoroughly rinse the material container with warm, soapy
water (or mineral spirits for oil-based materials).
2.
Disassemble the spray gun and clean all parts with warm
soapy water (or mineral spirits for oil-based materials).
Reassemble all parts when clean.
3.
Clean the air vent (a) on the suction tube with a soft
bristled cleaning brush.
4.
Clean the rear of the nozzle (b) with the appropriate
cleaning solution. Use a thin layer of petroleum jelly to
lubricate the O-ring (c).
10
1
2
3
4
EN
(a)
(c)
(b)