Maintenance - WAGNER CONTROL PAINTER Manual De Usario

MAINTENANCE

CLEANING THE FILTER
Before every use, you should inspect the air filter
in the turbine to see if it is excessively dirty. If it is
dirty, follow these steps to replace it.
Attention
Never operate your unit without the air filters. Dirt
could be sucked in and interfere with the function
of the unit.
1.
Press the tabs at the rear of the turbine. Slide the rear housing
off of the back of the turbine.
2.
Remove the dirty filter from the turbine and replace with a
new one. The smooth side of the air filter must be placed
toward the turbine.
Secure the cover back onto the turbine.
CLEANING THE AIR VALVE TUBE
If spray material ever enters the air valve tube,
i
follow the steps below.
1.
Pull the air tube (a) at the top from the nozzle. Screw off the
valve cover (b).
Remove the valve seal (c). Clean all the parts carefully. Make
sure to remove any material from valve seal housing area (d).
The air tube and valve seal (c) are only solvent-
resistant to a limited extent. Do not immerse in
solvent, only wipe.
Attention
2.
Place the valve seal (c) in the valve cover (b) with the pin
facing into the tube. Installing the valve seal into the valve
cover will be much easier if the valve cover is inverted.
3.
Turn the nozzle upside down and screw on the valve cover
(with valve seal inside) from underneath. Turning the nozzle
upside down will prevent the valve seal from falling out of the
valve cover during reinstallation.
4.
Place the air tube on the valve cover and on the nipple at the
nozzle.
1
(a)
(b)
(c)
2
3
4
EN
PRESS
(d)
(c)
(b)
11