Installation Instructions - DURAVIT SensoWash 22265900 Serie Instrucciones De Montaje

Important information
About the mounting instructions
These mounting instructions come as part of the
Duravit Shower WC and should be read carefully prior to
installation.
Explanation of the key words and symbols
DANGER! At high risk of fatal hazards or
serious injuries
NOTE! To avoid property damage
Link to the Electrical Installation section
Link to the installation information in this section
Link to the Water Installation section
Inspection (e.g. for scratches)
Do not kink hose
Check for leaks
Flush
Target readership and qualifications
The Shower WC and associated water connection may only
be installed by qualified plumbers. The electrical installa-
tion may only be carried out by qualified electricians.
NOTE!
Local installation regulations, country-specific standards
and the low voltage directives must be observed at all
times.
NOTE!
Do NOT install the Shower WC in rooms where there is a
danger of frost. The room temperature must not be less
than 4 °C.
Safety instructions
DANGER!
Risk of fatal electric shock.
> Do NOT remove individual Shower WC components.
6

Installation instructions

These instructions describe the installation of the
SensoWash wall-mounted toilet with an installation kit
for front-wall elements with ductwork. The instructions
enclosed with the wall-mounted toilet are only valid for the
wall-mounted toilet without an installation kit and should
therefore be disposed of.
The Shower WC unit installation is described in separate
instructions.
4
Checking the pre-installation (Diagram 4)
> Check whether the push plate of the front-wall
element and wall-mounted toilet are disassembled.
Disassemble other elements if necessary.
> Check whether the electrical installation has
already been carried out.
Drilling a hole to the ductwork in the front-wall
5
element (Diagram 5)
> Take clearances x and y to the front-wall element
from the documentation.
> Mark the drill holes.
> Drill a hole to the ductwork.
16
Measuring clearance y (Diagram 16)
19
Installing sound insulation set (Diagram 19)
> if the sound insulation set is included with the
delivery, take z into account in the clearance
between the wall and bolt:
Clearance = z+y+22.
> Screw the bolt onto the hanger bolt until you
achieve the calculated clearance to the wall.
> Install the sound insulation set.
27
Attaching the ceramics to the wall (Diagram 27)
> Position the ceramics on the wall. Ensure that the
hose is not kinked or trapped.
SensoWash_MAL_WWC+Montageset#100691_56918/15.10.2