Noise Emission Specifications; Vibration Specifications; Scope Of Supply; Safety Devices - Mafell ZSX Ec Serie Manual De Instrucciones

2.4 Noise emission specifications

The noise emission values ware determined according to EN 60745-1 with the following deviation: The
workpiece used was a fir wood beam as sawn with a thickness of 100 mm. The emission values amount to:
Idling
Machining
The values stated are emission levels. Although there is a correlation between emission and imission level, it
cannot be reliably derived from this whether additional precautions are necessary. Factors influencing the
current immission level existing at the workplace comprise the duration of exposure, the room characteristic,
other source of noise, etc. such as e.g. the number of machines and other adjacent machining operations. In
addition, the permissible immission level may differ from country to country. This information is nevertheless
suitable for providing the machine user with an improved assessment of the hazard and risk.

2.5 Vibration specifications

The typically assessed acceleration is 3.2 m/s

2.6 Scope of supply

Carpenter's chain saw ZSX Ec complete with:
Guide rail
Riving knife/splitter
Saw chains
1 parallel guide fence
1 service tool in bracket on the machine
1 operating manual
1 folder "Safety Instructions"

2.7 Safety devices

Danger
These devices are required for the
machine's safe operation and may
not be removed or rendered
inoperative.
The machine is equipped with the following safety
devices:
- protective equipment above the base plate
- bottom deflection with guard plate
- special design of the saw chain
- riving knife/splitter
Sound power level
111 dB (A)
108 dB (A)
.
2
Workplace-related emission value
100 dB (A)
97 dB (A)
260 HM
Special 260
260
2 x special
18 mm HM
- large base plate and parallel stop
- handles
- index mechanism with lock and brake

2.8 Use according to intended purpose

The carpenter's chain saw is exclusively suited for
longitudinal and cross cutting of solid wood up to a
maximum thickness of 400 mm (15 3/4 in.)
exclusively using the special saw chain provided by
MAFELL, with the machine having to rest on the
workpiece with its base plate 3 (Fig. 1). The machine
may be operated by one person only. At the same
time, the machine must be held and guided by its two
handles 1 and 2 provided for that purpose.
Any other use than described above is not
permissible. The manufacturer cannot be held liable
for any damage arising from such other use.
-21-
400 HM 400 Q
Special 400 Special 3/8" 400
400 400
2 x special 2 x 3/8" cross and
longitudinal cut
18 mm HM