Sound Effects; Others - Panasonic SC-PM600 Instrucciones De Funcionamiento

Sleep timer
The sleep timer switches off the system after the set time.
1
Press [SETUP] repeatedly to select "SLEEP".
2
Press [R, T] to select the setting (in minutes) and
then press [OK].
To cancel, select "OFF".
Note:
• The remaining time is shown for a few seconds every
"SLEEP 1"
minute. is always shown when only 1 minute
remains.
• The sleep timer can be used together with the play timer.
• The sleep timer always comes first. Be sure not to set an
overlap of timers.

Sound effects

1
Press [SOUND] repeatedly to select the sound
effect.
2
Press [R, T] to select the setting and then press
[OK].
MY SOUND "SOUND 1", "SOUND 2" or "SOUND 3"
(Z"Saving the sound settings")
PRESET EQ "HEAVY" (default), "SOFT", "CLEAR",
"VOCAL" or "FLAT"
BASS –4 to +4 (default: 0)
Using the main unit
1. Press [BASS/TREBLE] to select
"BASS".
2. Press [2/3] or [5/6].
TREBLE –4 to +4 (default: 0)
Using the main unit
1. Press [BASS/TREBLE] to select
"TREBLE".
2. Press [2/3] or [5/6].
D.BASS "ON D.BASS" (default) or "OFF D.BASS"
Using the main unit
Press [D.BASS] repeatedly.
SURROUND "ON SURROUND" or
"OFF SURROUND" (default)
Note:
Changed settings will be kept until it is changed again, unless
otherwise indicated.
Saving the sound settings
You can save the current sound effects (up to
3 combinations).
Preparation
Select the sound effects.
1
Press [SETUP] to select "SAVE MY SOUND".
2
Press [R, T] to select a sound setting number and
then press [OK].
"SAVED" is shown.
The new setting replaces the one existing in the same
sound setting number.
To recall the setting
1
Press [SOUND] to select "MY SOUND".
2
Press [R, T] to select the sound setting number
and then press [OK].

Others

Auto off
This system automatically switches off when you do not
use it for 20 minutes.
1
Press [SETUP] repeatedly to select "AUTO OFF".
2
Press [R, T] to select "ON" and then press [OK].
To cancel, select "OFF".
Note:
This function does not work when you are in radio source or
when a Bluetooth ® device is connected.
®
Bluetooth standby
This function automatically switches on the system when
you establish a Bluetooth
®
device.
1
Press [SETUP] repeatedly to select
"BLUETOOTH STANDBY".
2
Press [R, T] to select "ON" and then press [OK].
To cancel, select "OFF".
Checking the software version
1
Press [SETUP] repeatedly to select "SW VER." and
then press [OK].
The software version is shown.
2
Press [OK] again to exit.
connection from a paired
9
9