Getting Started -Notes For Before Installation; Installation For Windows 8.1, 8, 7 - J5create JUA350 Manual Del Usuario

GETTING STARTED –Notes for Before Installation
Install driver completely before inserting the USB 3.0 Display Adapter USB

Cable into your computer
Run the setup program as an administrator to avoid errors in installation

Uninstall the previous driver first before updating the latest driver

Connect the HDMI connector or the HDMI to DVI convertor of the USB 3.0

HDMI Display Adapter to the HDMI or DVI cable of the display device. Then
connect the device to the USB port of the computer
It is recommended to use an independent power supply for USB Hub while

multiple dongles are connected to the USB Hub
The display screen will flash during installation


INSTALLATION FOR WINDOWS 8.1, 8, 7

Device Driver Installation
This section illustrates the procedure for device driver installation for Windows 7. To
start, insert the Driver CD into your computer's CD-ROM drive. The setup program
should be launched automatically. If Autorun does not begin, go to "Computer", Click
on your optical drive, and manually run the setup CD by double-clicking on
"Setup.exe"
※Please make sure the USB cable of USB 3.0 Display Adapter is unplugged from your
PC or Notebook before executing the installation program.
1. The installation page will be launched. To start click on " Install the Latest Driver".
Please make sure the network is available or press "Install Driver" to start the
installation
2. After pressing the installation option, the InstallShield Wizard will launch, click
8