Automode; Filter Saturation Alarm; Alarm Messages; Hood To Hob Connection - Franke Frames FS TS 906 I XS Manual Del Usuario

EN

AutoMode

The hood is designed to work automatically linked
with the hob.
The automode function is automatically set when
your are starting a cooking and the hob is operating.
The icon lights up and the lighting goes on. The
speed level will be increased automatically by the
hob.
If you manually choose a certain speed or switch the
ventilation off, the AutoMode function is deactivated.
After cooking and switching off the hob, the hood
waits roughly 60 seconds before switching off
(ventilation and lighting).
Reactivate the AutoMode
Briefly press
X X
The icon of the key
„ „

Filter saturation alarm

The alarm for cleaning the grease filter turns on after
100 hours of effective running time of the hood.
The alarm for changing the odour filter turns on after
200 hours of effective running time of the hood.
Activating the alarm „filter saturation"
Press and hold
X X
All icons blink 2x. The alarm is activated.
„ „
Deactivating the alarm „filter saturation"
Press .
X X
All icons blink 1x. The alarm is deactivated.
„ „
Resetting the „filter saturation"
Press and hold
X X
All icons blink 3x. The alarm is reset.
„ „

Alarm messages

Alarm 1 „Grease filter saturation"
When alarm 1 occurs you have to clean the grease
filter.
The icons of the keys
Clean the grease filter.
X X
Alarm 2 „Odour filter saturation"
When alarm 2 occurs you have to change the odour
filter and clean the grease filter.
The icons ot the keys
Change the odour filter.
X X
Clean the grease filter.
X X
.
lights up.
for 2 seconds.
for 2 seconds.
and are blinking.
and are blinking.
FS TS 906 I XS

Hood to hob connection

Some models of this hood can be paired with
specific hobs to establish a hood-hob-connection.
When using for the first time, it may be neccessary
to establish the pairing of the hood with the hob.
Pairing of hood and hob
Switch-on a new hood and a new hob within 1
X X
minute one each other.
The pairing procedure starts automatically.
„ „
During pairing procedure hood will „beep"
„ „
periodically.
After few minutes beeping pairing is completed
„ „
and the hood beeps with a specific sequence.
The hood and the hob are now able to re-connect to
their known partner each time they are switched on/
off.
Un-pairing of hood and hob
To un-pair hob or hood, repeat the following
sequence for each device.
5 sec. switch-on, 5 sec. switch off for 5 times.
X X
This procedure could be done for the hood and the
hob individually or for both devices.
After un-pairing the hood will restart beeping
„ „
waiting for a hob to reconnect.
The pairing will not restart until hob and hood are
switched off.
– 8 –