The Scope And Suggestions For Uses; How To Select Tightening Torque - Hitachi Koki DS 14DSFL Instrucciones De Seguridad Y Manual De Instrucciones

English

THE SCOPE AND SUGGESTIONS FOR USES

Work
Wood
Drilling Steel
Aluminum
Machine
screw
Screw
tightening
Wood screw

HOW TO SELECT TIGHTENING TORQUE

Clutch dial
position
1
Approximately 9 in.-lbs. (10 kg-cm)
3
Approximately 15 in.-lbs. (17 kg-cm)
7 Approximately 23 in.-lbs. (26 kg-cm)
13 Approximately 35 in.-lbs. (40 kg-cm)
17 Approximately 43 in.-lbs. (49 kg-cm)
22
Approximately 52 in.-lbs. (60 kg-cm)
High speed: approximately 71 in.-lbs. (82 kg-cm) (DS14DSFL)
Low speed: approximately 302 in.-lbs. (347 kg-cm) (DS14DSFL)
NOTE
The selected content shown in Table 4 indicates
the differences according to screw type, screw size
and material used.
CAUTION
●
While operating the Cordless driver drill, take care
not to lock the motor.
If the motor is locked, immediately turn the power
off.
If the motor is locked for a while, the motor or
battery will be burnt.
●
Do not tighten too strongly as the screw heads
will be damaged.
18
Table 5
Clutch dial position
1 – 22
1 –
Table 6
Tightening torque
approximately 106 in.-lbs. (122 kg-cm) (DS18DSFL)
approximately 400 in.-lbs. (459 kg-cm) (DS18DSFL)
Suggestions
Use for drilling purpose.
Use the bit and socket matching the screw
diameter.
Use after drilling a pilot hole.
Machine screw tightening
Screw tightening for soft
wood material
Screw tightening for hard
wood material
Thick screw tightening
When used as a drill.
Operation example