Blade Assembly; Light Kit Assembly (Optional). Pgs - Craftmade SON52 Guia De Instalacion

8. Blade Assembly.

Locate 6 blade screws, lock washers and flat
washers in one of the hardware packs. Place
1 lock washer and 1 flat washer (in that order)
on a blade screw. Repeat for each blade screw.
Turn blade so that the WIDE, DEEP holes for
the blade screws are turned toward the floor.
Raise blade to motor, aligning holes in blade
with corresponding holes in motor. Partially
insert 2 blade screws (along with the lock
washers and flat washers).
screws permanently,
remaining blades. Securely tighten all screws
only after all 3 blades have been attached.
Note: Tighten blade screws twice a year.dos
veces al año.
9. Light Kit Assembly (Optional).
If you wish to use the light kit, remove 1 screw
from motor plate on underside of motor
housing and partially loosen the other 2 screws.
Align slotted holes in center of fitter plate with
loosened screws in motor plate, allowing
female plug from motor housing to come
through hole in middle of fitter plate. Twist
fitter plate to lock. Re-insert screw that was just
removed and securely tighten all 3 screws with
Phillips screwdriver.
["Light Kit Assembly" continued on next
page.]
Before securing
repeat procedure for
flat washer
lock washer
blade screw
motor plate
female plug
page 7
motor
housing
blade
motor housing
fitter plate