Craftmade WB242 Manual De Instalación página 3

Preparation
Important: When using an existing outlet box, be sure the box is securely
attached to the building structure and can support the full weight of the fan.
Failure to do so can result in serious injury or death.
1
Step 1
Turn off circuit breakers and wall switch to the
fan supply line leads.
Warning: Failure to disconnect power supply prior to
installation may result in serious injury or death.To
reduce the risk of shock, this fan must be installed with
an isolating wall control/switch.
2
Check to make sure blades are at
least 30" from any obstruction.
Check downrod length to
ensure blades are at least
7' above the floor.
3
Prior to securing mounting bracket, screw "J" hook (S7) into ceiling
outlet box as a secondary support means. Secure mounting plate (1)
using screws and washers (S2) directly to the outlet box. Arrows on
mounting plate and fan body inner housing plate will line up (see step 6).
Be sure to position arrow on mounting plate in the direction that the
cowling on the fan body should face. If not mounting to an outlet box,
use wood screws (S1) and mount securely to a beam or joist.
Note: Do not mount directly to sheet rock or ceiling tile.
NOTE: J Hook installation is a Canadian requirement only.
Step 2
84"
(2.1m)
Min.
Step 3
3
"J" Hook (S7)
Ceiling
4
30"
Hang the fan motor/outer housing (2) onto the hook that is positioned
0.75m
Min.
on the mounting plate (1).
Cowling
Step 3 Continued
Support Beam
OUTLET BOX
Mounting Plate (1)
Wood Screws
& Washers (S1)
Screws & Washers
for Mounting Plate (S2)
Step 4
Mounting Plate
Fan Motor
Outer Housing (2)