Installing The Handset; Connecting The Ac - GE 25833 Manual Del Usuario

Installing the Phone
Choose the best location to install your base.Your base should be placed on a level
surface such as a desk or table top.
Installing the Handset Battery
NOTE: You must connect the handset battery before use.
1. Locate battery and battery door which are packaged together inside a plastic bag and
are separate from the handset.
2. Locate the battery compartment on the back of the handset.
3. Plug the battery pack cord into the jack inside the compartment.
NOTE: It is important to maintain the polarity (black and red wires) to the jack
inside the compartment. To ensure proper battery installation, the connector is
keyed and can be inserted only one way.
PRESS DOWN
FIRMLY
4. Insert the battery pack.
5. Close the battery compartment by pushing the door up until it snaps into place.
6. Place the handset in the base to charge.
Connecting the AC (Electrical) Power
On the base, plug one end of the power adaptor cord into the power jack on the back of
the base and the other end into an electrical outlet.
NOTE: If the battery is not properly installed in the handset, or if the battery pack
is not properly connected to the to the jack inside the battery compartment, "NO
BATTERY" shows in the display when the handset is placed in the charging cradle.
NOTE: The CHARGE/IN USE indicator on the base turns on to indicate the handset
battery is charging.
12
BATTERY
BLACK WIRE
RED WIRE