Publicidad
Idiomas disponibles
Idiomas disponibles
2
i
nstallation
Tools Required: 8mm x 10mm Open End Wrench, Screwdriver,
19 mm Wrench, 4 mm Hex Wrench
1.
Close choke and remove air filter and cover.
2.
Disconnect ignition stop leads (A) and (B).
3.
Remove inner throttle linkage from carburetor swivel (C).
4.
Loosen the two (2) drive shaft clamp bolts (D) at engine drive
shaft clamp, and remove center drive shaft location bolt (E). Pull
drive shaft assembly from cluth case.
5.
Loosen two (2) rear handle screws (F) and pull rear handle from
the drive shaft assembly.
6.
Loosen two (2) screws (G) and remove front handle.
U-H
K
andle
it
i
i
nstallation
nstrUctions
B
A
D
D
E
G
C
F
Publicidad
