Descargar Imprimir esta página

Echo 99944200675 Instrucciones De Instalación página 3

Publicidad

Idiomas disponibles

Idiomas disponibles

U-H
7.
Insert square nut (H) in lower handle bracket (I) and place bracket
on drive shaft 400mm (15 3/4 in.) from engine end of drive shaft.
8.
Secure with lower handle bracket clamp (J) and three (3) 5x30
mm hex socket bolts.
9.
Position harness clamp (K) 220 mm (8-5/8 in.) from engine end
of drive shaft assembly. Install 5x12 mm bolt, but DO NOT
tighten at this time.
10. Carefully fit drive shaft assembly to engine making sure inner
drive shaft engages into clutch socket.
11. Turn drive shaft housing until locating hole lines up with location
hole in clamp and install center drive shaft location bolt (E).
NOTE
Gear Housing must be aligned properly with engine. Aligning cen-
ter locating hole in driveshaft housing with center drive shaft bolt
(E) provides correct alignment.
12. Tighten two (2) drive shaft clamp bolts (D) securely.
13. Install upper U-Handle and bracket on lower bracket and secure
with one (1) 8x55 mm bolt (L) and large circular washer.
14. Route throttle linkage and ignition lead assembly behind U-Han-
dle bracket and clip to drive shaft as shown.
15. Install throttle linkage cable into fan cover clip (M)
K
i
andle
it
nstallation
i
nstrUctions
H
I
J
400 mm
(15-3/4 in.)
I
J
D
E
M
3
K
ENGINE
END
220 mm
(8-5/8 in.)
D
L

Publicidad

loading