Husqvarna FS7000 D Manual Del Usuario página 36

3. If it is necessary, remove the hydraulic reservoir cap
and fill the hydraulic reservoir until the oil level is
Technical data on page 45 for the
correct. Refer to
correct type of oil.
CAUTION: Do not fill too much. Oil can
come out of the inspection opening.
4. Install the hydraulic reservoir cap.
5. Install the plug in the inspection opening on the
hydraulic reservoir.
To replace the hydraulic oil
1. Remove the plug from the inspection opening on the
hydraulic reservoir.
2. Use a manual oil pump to drain the oil through the
inspection opening on the hydraulic reservoir.
3. Replace the hydraulic system filter. Refer to
replace the hydraulic system filter on page 34 .
To lubricate the product
1. Clean the 8 grease nipples.
• FS7000 D:
36
• FS7000 DL:
2. Replace broken or blocked grease nipples.
To
3. Lubricate the front wheels.
4. Lubricate the pivot bearings of the front axle.
5. Lubricate the blade shaft. Push the grease pump 2
times at each end of the blade shaft.
6. Lubricate the pivot pin on the hydraulic cylinder.
7. Lubricate the rear axle bearing.
For more information about lubrication, refer to
Technical data on page 45 .
1223 - 002 - 09.07.2019