Mi-T-M GEN-12000-1MHE Manual Del Operador página 27

maInTenanCe
CLEANING AND GAPPING SPARK PLUG:
If the plug is contaminated with carbon, remove it using a
plug cleaner or wire brush.
Check the spark plug gap and reset it if necessary. The spark
plug gaps are listed below. To change the gap, bend the side-
electrode only, using a spark plug tool. (Fig. 9)
Install and tighten the spark plug. Connect the spark plug
lead.
Recommended Spark Plug:
Engine Subaru
Spark Plug NGK BP6ES
Spark Plug Gap
Torque - New
Torque - Retighten
SPARK ARRESTOR:
If the generator has been running, the muffler will be very
hot. Allow it to cool before proceeding.
NOTE: Remove and clean spark arrester every 100 hours
or as necessary.
NOTE: Product users on United States forest service land,
and in some states, must comply with fire prevention
regulations.
Clean the spark arrester as follows: (Fig. 10 and 11)
1. Remove the screw from the muffler and remove the spark
arrester.
2. Use a brush to remove carbon deposits from the spark
arrester screen. Be careful to avoid damaging the
screen.
The spark arrester must be free of breaks and holes.
Replace the spark arrester if it is damaged.
3. Install the spark arrester and muffler protector in the
reverse order of disassembly.
Spark arrestors are available from your local Mi-T-M Customer
Service Representative. Other user requirements may apply,
check with your Federal, State or local authorities.
Operator's Manual
Honda
NGK ZGR5A
0.7 - 0.8 mm (0.03 in.)
8.7-10.9 ft-lb
16.6-19.5 ft-lb
Service
Spark Plug Gap
(See recommendations)
(Fig. 9)
(Fig. 10)
(Fig. 11)
27