Taking Care Of The Guide Bar; Motor Cooling - Stihl MSE 250 C Manual De Instrucciones

English

Taking Care of the Guide Bar

2
1
Turn the guide bar over – every time
N
you sharpen the chain and every
time you replace the chain – this
helps avoid one-sided wear,
especially at the nose and
underside of the bar.
Regularly clean the oil inlet hole (1),
N
the oilway (2) and the bar groove
(3).
Measure the groove depth – with the
N
scale on the filing gauge (special
accessory) – in the area used most
for cutting.
Chain Chain pitch Minimum
type groove depth
Picco 1/4" P 0.16" (4.0 mm)
Rapid 1/4" 0.16" (4.0 mm)
34
Picco 3/8" P
Rapid 3/8"; 0.325"
Rapid 0.404"
If groove depth is less than specified:
Replace the guide bar.
N
The drive link tangs will otherwise
scrape along the bottom of the groove –
the cutters and tie straps will not ride on
the bar rails.
3
0.20" (5.0 mm)

Motor Cooling

0.24" (6.0 mm)
0.28" (7.0 mm)
Use a dry brush or similar tool to
N
clean the cooling slots at regular
intervals – see "Maintenance
Chart".
MSE 250 C