Maintenance - Truper CALA-A3 Instructivo

Cut wood sheets
When cutting most wood sheets or very thin wood use a
blade with fine teeth. Reduce splinters in the edges. Clamp
scrap pieces of wood onto both faces of the work piece
and start cutting.
CAUTION
Do not use the balancing action when
cutting much closed circles or angles.
Work
piece
WARNING Disconnect the tool from the power source
before making adjustments, service o maintenance to the
Jigsaw.
Cleaning and Care
• Keep the tool free of dust. Never use water or chemical
cleaning solutions. Clean the tool only with a clean and dry
cloth.
• Keep the ventilation slots clean and free of debris to
guarantee the right cooling of the motor.
• Check the feeding cable regularly to look for any
damages. In case the cable is damaged change it in a
Authorized Service Center.
Service
• The tool shall only be serviced in a
Authorized Service Center. Service and maintenance carried
out by non-qualified people may be dangerous and could
cause severe personal injury. It also makes the product
Warranty void.
8
ENGLISH
Scrap
wood
Start up
Straight cut
To get much defined straight cuts use the parallel guide
supplied with the tool. Support the guide to the work piece
edge.
Straight cuts can also get a fine finish by cutting slowly over
a line previously marked.
Circular cut
Circular cuts can also get a fine finish if cutting slowly over
a line previously marked similar to the straight cut. With a
circular guide (not included) the Jig saw can make perfect
circular cuts.

Maintenance

Carbon Brush Replacement
• Carbon brushes need to be checked regularly and when
worn, replaced in a
Service Center. After the carbons have been replaced, ask
the technician to inspect if they run freely in the carbon
housing and to let run the machine 5 minutes to make
even the contact of carbon and commuter.
• Use only
brushes, designed specifically with the strength and electric
resistance fit for each type of motor. Carbon brushes that
are out of specifications may damage the motor.
• When replacing carbon brushes always change both
pieces.
Lubrication
• Regularly apply
a drop of lubricant
to the roller guide
for proper blade
slippage when
cutting.
Authorized
original spare carbon