Safety Instructions - ALFRA TML 90R Manual De Istrucciones

Dear customer,
Thank you for purchasing an ALFRA product. Please read these operation instructions closely before using your
device for the first time and keep them along with the enclosed Product Control Card for later reference.

Safety instructions

Dangers can occur when transporting loads by lifting devices due to improper handling and/or poor maintenance,
which may cause serious accidents with fatal physical injuries. Please read these operation instructions closely and
observe all safety instructions mentioned therein. Contact the manufacturer if you have any questions.
Always...

activatetheliftingmagnetcompletely

activate the lifting magnet on metallic, ferromagnetic materials

use the entire magnetic surface for lifting

lift on plane surfaces

lift round pipes with the correct diameter

ensure that the pipe is positioned correctly in the groove when using the lifting magnet on
round pipes

check the magnetic holding force by lifting the load slightly by about 10 cm

clean the magnetic surface and keep it clear of dirt, chips and welding sputter

set the lifting magnet down gently to prevent damage to the magnetic surface

check the hazard area before pivoting the load

respect the stated maximum load before pivoting

inspect the magnetic surface and the entire lifting magnet for damage

usesuitableliftinggear

follow the instructions in these operating instructions

instruct new operators to the safe use of lifting magnets

respect local, country-specificguidelines

store in a dry place
Never...

exceed the stated maximum load

lift arched objects or objects with free form surfaces

lift round pipes of a too big or too small diameter

lift loadsoverpeople

lift more than one work piece at a time

switch the lifting magnet off before setting down the load safely

allow the load to sway or bring to a sharp and immediate stop

lift loads exceeding the recommended dimensions

lift loads with cavities, cut-out openings or drilled holes

liftunbalancedloads

modify the lifting magnet or remove operating labels

use the lifting magnet if damaged or missing parts

strain the underside of the magnet through heavy impact or blows

position yourself beneath the lifted load

lift loads while people are within the hazard area

leave the load hanging unattended

use the lifting magnet without having been properly instructed

use if you have not read and understood these operating instructions completely

use the lifting magnet to support, lift or transport persons

operate the lifting magnet in temperatures higher than 60°C (140°F)

expose to corrosive substances
People using pacemakers or other medical devices should not use this lifting magnet until
they have consulted with their physician.
14