Troubleshooting; Safety Notices; Cause And Action - Caso MyVac 20 Manual De Instrucciones Original

17 Troubleshooting

17.1 Safety notices

17.2 Cause and Action

Failures
The vacuum sealer
does not function
The charging device
does not charge
The device does not
work after charging
The vacuum produced
caso Vakuumierer MyVac 20
Please note
► The airproof loop of sponge should be dried thoroughly prior
to reassembling.
► When re-assembling, be careful to prevent any damage and
assembles as original position to ensure no vacuum leaking.
This chapter provides you with important notices with regard to
operating the device. Observe the following notices to avoid
dangers and damages:
Attention
► Only qualified electricians, who have been trained by the
manufacturer, may carry out any repairs on electrical
equipment.
► Improperly performed repairs can cause considerable
dangers for the user and damages to the device.
In the event of a fault, an error code will appear in the display; it
describes the cause of the fault.
Possible Cause
The device hasn't been used
for a longer period and the
battery is weak
The accessories are only
loosely put on
Defective socket
The charging device and the
charging station are not
connected correctly
The charging time was too
short
► Close the zip catch once again
Resolution
► Recharging
► Check all parts are put on
firmly
► Look for a proper socket
► Check the connection
► Fully charge the device as
described under Recharging
52