Rs838-Rs839; Rs908; Rp770; Before Use - Mopedia RS825 Manual De Instrucciones

6

8.4 RS838-RS839

1. Reverse the seat, take the two u-shape frames of the legs and tighten them to the center
of the seat using one of the short screws provided;
2. For RS839, take the backrest supports and tighten them to the seat and to the leg
supports using the long screws;
3. For RS839, tighten the backrest to their supports using the remaining short screws;
4. Add the 4 legs and fix them at the desired height.

8.5 RS908

1. Connect the two lateral frames with the connecting bars, for fixing, use the clips supplied;
2. Once the frame is fully assembled with all four clips, you can adjust the height of the legs
(see section 11.3 How to use).

8.6 RP770

1. Position the handles in the same attachment point of the toilet seat;
2. Reposition the tablet and screw;
3. Adjust the height of the legs. Press the stop, slide the tube bringing it to the desired height.
Release the stop, check the stability of the product and check if all legs are the same height.

9. BEFORE USE

• Check if the frame is damaged in order to guarantee a safe use for people and things.
• Check the correct assembly of the device.

10. CAUTIONS FOR USE

The manufacturer and distributor are not responsible for any responsibility for the
consequences of improper use of the product.
• Always help the patient with walking difficulties to position themselves on the seat.
• Do not use with patients who exceed the maximum weight shown on the label placed on
the product frame.
• Avoid sudden movements during positioning.
• Be careful on wet floors, on wet or slippery surfaces, it could make difficult the patient
positioning.
• Do not store the product outside. Periodically check the stability of the product and the
correct fastening screws and the status of protections rubber.
• In case of doubt for the use, the adjustment or the maintenance of the product, please
contact your dealer.
WARNING!
Do not exceed the maximum load capacity for any reason!

11. HOW TO USE

11.1 RS825-RS826

Height adjustment
Remove the 4 clips. Adjust the height of the 4 legs (RS826) or wheels (RS825) according to
your own need. Reposition the 4 clips in the corresponding holes to lock the legs (RS826) or
wheels (RS825) at the selected height. Make sure the pin has completely penetrated the hole.